Answers are grounded in this paper and cite their sources.
A study to investigate fusion bonding (welding) of AS4 graphite/polyetheretherketone (PEEK) thermoplastic composites is presented. Processing studies are conducted for resistance welding preconsolidated AS4/PEEK laminates in both unidirectional and quasi‐isotropic configurations using PEEK and polyetherimide (PEI) film at the joint interface. All bonding was done under a constant displacement process. The influence of processing time, initially applied consolidation pressure, and the rate of heat generation on weld performance is examined through lap shear and Mode I interlaminar fracture toughness testing. A rapid increase in strength with processing time that asymptotically approaches the compression molded baseline is measured. Weld times for quasi‐isotropic lap shear coupons are significantly shorter than those with a unidirectional lay‐up. Variation of the initially applied consolidation pressure is shown to have little influence on the lap shear strength of PEEK film welded lap joints. A discussion of the mechanisms allowing void formation during the welding process is given. Bond strength test results are correlated with ultrasonic C‐scans of the weld regions.
No takes yet. Share an insight, caveat, or question.
Don et al. (1992) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: