Key result
A software solution for designing custom-made hip prostheses based on B-spline surfaces produced designs with deviations smaller than the errors caused by diagnostic imaging.
Why the study?
To establish a methodology for hip joint prosthesis design that provides the foundation for automating all stages of custom-made prosthesis development.
A new methodology using B-spline surfaces for custom-made hip prosthesis design produces models with deviations smaller than diagnostic imaging errors.
Answers are grounded in this paper and cite their sources.
May enable precise custom hip prostheses; leaves open clinical validation and adoption.
Replacement of a natural hip joint with an artificial is one of the most commonly used surgical procedures in orthopaedic surgery. This paper describes the methodology of the hip joint prosthesis design, which presents the foundation for the automation of all stages of the development of custom-made prostheses. A general mathematical model based mostly on B-spline surfaces is used in order to define the prosthesis geometry. In order to verify the method, a software solution was developed and used for designing prostheses based on ten diagnostic images obtained by various methods. The results of the analysis of the ten designed prostheses, out of which five manufactured, show that deviations from the desired values are less than the errors caused by diagnostic imaging.
No takes yet. Share an insight, caveat, or question.
Tabaković et al. (2019) studied Hip joint replacement (n=10). Custom-made hip joint prosthesis design methodology was evaluated on Deviations from desired values in prosthesis geometry. A software solution for designing custom-made hip prostheses based on B-spline surfaces produced designs with deviations smaller than the errors caused by diagnostic imaging.
Synapse has enriched 10 related papers. Consider them for comparative context: