Answers are grounded in this paper and cite their sources.
In this paper, two commercial polymers, poly(vinyl ethyl ether) (PVEE) and poly(1-decene) (P-1-D), are tested to thicken CO 2 for CO 2 enhanced oil recovery (EOR). First, a series of laboratory tests are conducted to measure the cloud-point pressures of either polymer at different polymer solubilities in supercritical CO 2 and the equilibrium interfacial tensions (IFTs) of a light crude oil-pure or polymer-thickened CO 2 system under different reservoir conditions. Second, a capillary viscometer is used to measure the viscosities of polymer-thickened CO 2 at different test pressures. Third, a total of six high-pressure CO 2 coreflood tests are performed to examine the effects of polymer-thickened CO 2 on the total CO 2 EOR. It is found that at the same and low polymer solubility in pure CO 2, the measured cloud-point pressure of PVEE is much lower than that of P-1-D. The measured equilibrium IFT for polymer-thickened CO 2 at a high pressure is much lower than that for pure CO 2 . The PVEE- or P-1-D-thickened CO 2 viscosity is approximately (13 to 14) times higher than the pure CO 2 viscosity. The CO 2 coreflood test results show that PVEE- or P-1-D-thickened CO 2 flooding can further enhance oil recovery after a pure CO 2 breakthrough. The CO 2 breakthrough can be significantly delayed if polymer-thickened CO 2 is injected directly.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2011) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: