This is the authors' abstract. We don't add key points for this paper.
The microstructures and mechanical properties of dissimilar arc stud weldments between ASTM Monel 400 and ASTM F568 steel stud were investigated. Welding currents of 400, 525, and 800 A with welding times of 0.2–0.4 s were used. Optical microscopy (OM), scanning electron microscopy (SEM), X-ray diffraction (XRD), and energy-dispersive X-ray spectroscopy (EDS) were employed for microstructural analysis. Mechanical properties were assessed through torque strength and microhardness tests. The fusion zone (FZ) and heat-affected zone (HAZ) of Monel 400 displayed columnar grains, while reinforcement fillet grains were equiaxed. SEM revealed solidification cracks at high currents. Increasing temperature transformed the steel stud’s microstructure. XRD analysis identified FeNi3, CuNi, and martensite as primary phases in the FZ. Ni and Cu diffused into the steel HAZ, while C and Fe migrated toward Monel 400. The welded joints achieved peak torque strength of 70 N•m at 525 A and 0.3 s, with failure in the stud shank. A hardness of 703 HV was detected in the steel stud’s HAZ at 800 A and 0.3 s. Higher welding current increased the hardening depth and martensite formation in FZ and HAZ, affecting mechanical performance.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Razzaq et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: