This is the authors' abstract. We don't add key points for this paper.
The filling combination of polytetrafluoroethylene (PTFE)/Cu/Al2O3 filled poly(methyl methacrylate) (PMMA) based composites aiming at low friction and wear is optimized based on L9(34) by Taguchi method. The worn morphologies of PMMA based composites are analyzed by scanning electron microscopy (SEM). The PTFE transfer film and the wear debris on the steel ball surface are analyzed by SEM and X‐ray spectroscopy. It is observed that the friction and wear of PMMA can be obviously decreased by filling with PTFE, Cu, and Al2O3. PTFE has the most significant but Cu has the negligibly smallest contribution on both the friction coefficient and the wear rate. The lower friction coefficient (<0.2) appears by the combination of the mass ratio of PTFE larger than about 4.5% and the mass ratio of Al2O3 lower than ∼7.5%. The lower wear rate (<5 × 10−5 mm3/Nm) appears by the combination of the mass ratio of PTFE larger than about 5% and the mass ratio of Al2O3 lower than ∼8%, but it does not include that PTFE is greater than about 8.5% and Al2O3 is less than about 1.5%.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Gu et al. (2018) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: