Answers are grounded in this paper and cite their sources.
Ohmic contacts have been fabricated on Si-doped GaN using Ti/Al by low temperature annealing at 500 °C. A contact resistivity of 8.6×10 -6 ohm cm 2 was obtained for n-GaN samples doped to 3.67×10 18 cm -3 . Secondary ion mass spectrometry (SIMS) analysis showed that Al diffused through the Ti layer after annealing. Furthermore, energy dispersive x-ray spectroscopy (EDS) analysis showed that reaction products of Al, Ti, Ga and N were present at the interface. Hence, a complex ternary or quaternary nitride as a possible low barrier height material to n-GaN may have resulted in good ohmic contact. Photoluminescence (PL) showed that there was no degradation in the epilayer quality of the film after annealing at 500 °C for 25 minutes.
No takes yet. Share an insight, caveat, or question.
Tan et al. (2000) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: