Answers are grounded in this paper and cite their sources.
+TiC(30-40%). In these cases, adequate flushing of erosion products is hampered by the geometry of the working space or by the small value of the required discharge gap, which does not exceed 2.2-2.5 μm. The methods of adaptive control in modern computer numerical control systems of EDM equipment based on measuring the electrical parameters in the working zone have been shown to be ineffective in the cases described above. This study aims to investigate the natural phenomena of material sublimation under discharge pulses for conductive ceramics and nanocomposites. The measured conductivities of the samples are higher than the percolation threshold. However, the question of machinability remains open owing to detected processing interruptions and poor quality of machined surfaces. New knowledge on EDM of conductive ceramics and nanocomposites can improve the final quality of the machined surfaces and productivity of the method by the introduction of advanced monitoring and control methods based on acoustic emissions. The manuscript presents an up-to-date overview and current state of the research on the subject area. The obtained morphology of the samples and discussion of the findings complete the experimental part of the study. The scientific basis for a new type of adaptive control system is provided. This can improve the effectiveness of parameter control for machining conductive ceramics and nanocomposites and contribute to an increase in the EDM performance for the most critical cases.
No takes yet. Share an insight, caveat, or question.
Grigoriev et al. (2019) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: