Answers are grounded in this paper and cite their sources.
The paper describes a method for obtaining the behavior of fracture characteristics of carbide tool materials under such conditions that are encountered in interrupted turning operation. For this purpose, the impact tension and the impact compression loading testing machines are designed, in which a control of loading rate or a rising time of load as well as applied stresses and cycles is arbitrarily possible. The results obtained for carbide materials, K 20, P 20, under roomtemperature are summarized as follows : (1) The fracture characteristics of carbide materials, considered as extremely brittle materials, are also deteriorated like a fatigue seen in a ductile material by cyclic loading. They have the feature that the fracture stresses decrease and the scatter of them increase, while the maximum fracture stress changes little in Weibull's distributions. (2) The deterioration rate greatly depend on the loading rate. The impact loading give the larger deterioration than the static one or the slow loading rate even under thesame stress and cyclic number. (3) The threshold stresses are found in both impact tension and compression deteriolation stresses. The impact stresses below this threshold one never give any deterioration in tool material even in the increase of cyclic number of load.
No takes yet. Share an insight, caveat, or question.
SHIRAKASHI et al. (1982) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: