Answers are grounded in this paper and cite their sources.
The mechanical behavior of various classes of inked and non‐inked (dry) open‐cell foam rollers has been investigated from stress/strain measurements in compression. Hysteresis, creep, and recovery in dynamic loading were used to differentiate the rollers as to their utility in printing applications. Creep, ϵc(t), and recovery, ϵr(t), were determined in a compression mode from force measurements and strain decay, ϵ(t), i.e., Δϵc(t) = ϵ0 – ϵ(t) [ϵ0 = ϵ(t = 0)] or ϵc(t) = 2ϵ0 – ϵ(t). The creep function, Δϵc(t), represents the plastic strain, ϵpl(t = th), and is uniquely defined from the recovery function, Δϵc(t) = ϵr(t = th), where th is the hold or contact time. The recovery results for a polyurethane ester (PUE) and acrylonitrile/butadiene (AB) rollers (dry/ink), poly(vinylidene fluoride) film (PVF2) (air/vapor) and low‐density polyethylene film (LDPE) (air/vapor) were found to fit a master curve of the form Fr(θ) = EXP[‐Kr(th)θ] = [ϵr(t) – ϵ∞(th)]/[ϵ0(t = O) – ϵ∞(th)] at a reduced time of Kr(th)θ {θ = t/th and Kr(th) = k′r(th)th = C0/(th)α−1 (where C0 depends on the material's “dry” or “wet” state, α is a function of the type of material, and ϵ∞ is the permanent set). These empirical results are consistent with the observed decreases in print intensity during transfer to a paper substrate and weight changes of the roller, i.e., creep and recovery are important in the printing characteristics of a given roller material. Other factors of importance in the overall transfer and print quality, but of longer‐term considerations, are diffusion processes within the polymer and the nature of the polymer (e.g., porosity, chemical constitution, surface and interfacial tensions).
No takes yet. Share an insight, caveat, or question.
Phillips et al. (1992) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: