Answers are grounded in this paper and cite their sources.
This study investigates the optimal heat-treatment condition for improving straightness during cold drawing while maintaining the strength and machinability of an extruded Cu–Zn–Si alloy. Particular attention is given to the evolution of the metastable κ phase and its influence on residual stress and machining behavior. Heat treatment at 400 °C promotes the decomposition of the κ phase into Cu 3 Si intermetallic compounds, whereas treatment at 600 °C induces a κ-to-α phase transformation. The κ-to-α transformation generates severe lattice distortion and increases internal residual stress, leading to deterioration of dimensional stability during drawing. In contrast, heat treatment at 400 °C for 1 h retains a moderate fraction of the κ phase, facilitating chip segmentation, maintaining low cutting force, and suppressing residual stress development. As a result, this condition provides the optimal balance between machinability and dimensional stability, enabling improved straightness after drawing. These findings demonstrate that controlled κ-phase evolution can effectively tailor the microstructure of Cu–Zn–Si alloys, highlighting their potential as high-machinability Pb-free brasses for industrial applications
No takes yet. Share an insight, caveat, or question.
Kim et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: