Answers are grounded in this paper and cite their sources.
To meet the demand for lightweight and highly reliable joining of thin-walled aerospace structures while preserving structural integrity, dissimilar 2B06-T42/7B04-T74 aluminum alloy lap joints were fabricated by refill friction stir spot welding (RFSSW) using a sleeve with an outer diameter of 5 mm, and the effects of rotation speed and plunge depth on the cross-sectional characteristics, tensile-shear properties, and fracture behavior of the joints were systematically investigated. The results showed that downward-oriented hooks reduced stress concentration and improved joint strength, whereas an increase in the height of upward-oriented hooks led to a decrease in tensile-shear load. Cracks initiated at the original faying interface and propagated along the hook, and the final crack path was jointly affected by hook geometry and local hardness distribution. Within the investigated parameter range, the joint produced at 1,200 rpm and 1.0 mm exhibited the maximum tensile-shear load of 3,286 N. These results demonstrate that appropriate control of rotation speed and plunge depth can effectively improve the performance of small-spot-diameter joints produced using a 5 mm sleeve outer diameter.
No takes yet. Share an insight, caveat, or question.
Yang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: