Answers are grounded in this paper and cite their sources.
Despite the numerous benefits of minimum quantity lubrication (MQL), it is yet to be used in small- and medium-scale machining industries due to the high cost of commercial MQL oils. The use of externally supplied MQL in drilling is challenging, as the cutting zone is inaccessible, and achieving good performance becomes difficult with increasing drilling depth due to the shadowing effect of the workpiece, which obstructs the aerosol. MQL and flood cooling in drilling AISI 304 steel with two different drill depths, 10 mm, and 15 mm are studied with a cutting speed of 35.46 m/min and feed rate of 0.05 mm/rev. To assess the penetration efficiency, cutting temperature is measured using a thermocouple inserted into the coolant hole of the through coolant drill held in a specially modified tool holder to perform drilling in a lathe. The maximum temperature obtained for MQL and flood cooling for 15 mm drill depth is 362.4°C and 163.8°C, respectively, with a percentage difference of 121.1%. Due to the workpiece shadowing effect, the lubricant/coolant reaching the cutting zone decreases drastically beyond 9 mm drill penetration for MQL and 12 mm penetration for flood cooling.
No takes yet. Share an insight, caveat, or question.
Srinivasan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: