Answers are grounded in this paper and cite their sources.
Water management remains a critical challenge in polymer electrolyte fuel cells (PEFCs), as excessive liquid water accumulation can obstruct reactant transport, destabilize cell voltage, and reduce performance. In this work, the established liquid bridging principle of interdigitated electrodes is implemented using directly laser-written, uncoated laser induced graphene (LIG) electrodes for over-humidification detection under PEFC-relevant conditions. The resulting LIG-based moisture analyser (LIGMA) is fabricated by CO 2 laser patterning of polyimide without masks or additional humidity sensitive coatings. Raman spectroscopy confirms graphitic carbon formation, while scanning electron microscopy reveals the characteristic porous and fibrous LIG morphology. Different IDE geometries are evaluated to determine the influence of finger spacing and active area on droplet response. The sensors show response times of 1-4 s, and the fine geometry reliably detects the smallest investigated droplet volume of 2 µl under the defined deposition protocol. This value is reported as the minimum experimentally tested and detected volume. The voltage response is interpreted as a coupled process involving liquid water bridging, capillary spreading and retention within the porous LIG network, and possible interfacial effects. During 100 h exposure to humidified hydrogen and air, the sensors remained electrically functional and showed no visible delamination, cracking, or pore collapse in the examined regions. Initial testing at the cathode outlet of an operating PEFC shows pronounced signal changes during extended outlet wetting. The results demonstrate the potential of directly patterned LIG IDEs as simple outlet side indicators for condensation and liquid water breakthrough in PEFC systems.
No takes yet. Share an insight, caveat, or question.
Käfer et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: