Answers are grounded in this paper and cite their sources.
T he deep drawability (R.-value) was studied in rimmed steel sheets melted in air.The variables examined were the carbon content, the cold rolling reduction (50 to 90% ), and the annealing conditions (700 0 and 800 0 e X 5 hr in non-decarburizing atmosphere or 750 0 e X 10 hr in decarburizing atmosphere).The following conclusions have been reached:(1) The R -value not only has the well-known dependence upon the texture but also the dependence upon the grain size d, which can be expressed by the formula. B. = R o+k(d-I f2-do-I f2)I n this formula , (i) the R-value at the completion of recrystallization, is mainly determined by cold rolling reduction and carbon content; (ii) Ikl is almost constant at 50 to 80% cold reduction, though decreases over 85%; Ciii) (d -If2 _ do -l f 2 ), the term expressing the effect of grain growth after the completion of recrystallization, is affected by such factors as carbon and oxygen contents and annealing conditions; (iv) a high R-value can be obtained in low carbon material by non-decarburi zing annealing, and in the high carbon (that is, low oxygen) material by the decarbllrizing; and (v) the B.-value of low carbon material can be raised through the increase in R o and that of high carbon material through the increase in I d -I f 2 -do -1;21• (2) When carbon content is low or annealing temperature high, the cold rolling redllctionfor getting maximum R-value is high.
No takes yet. Share an insight, caveat, or question.
Matsudo et al. (1970) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: