Answers are grounded in this paper and cite their sources.
Stretch-flange-formability is an important property for ultra high strength steel (UHSS) sheets for press-forming. In this study, microscopic deformation behaviors during punching and following stretch-flange-forming were investigated using three types of 980 MPa grade UHSS sheets with either two ferrite/martensite dual-phase structures or a martensite single-phase structure in order to clarify how the microstructure affects the stretch-flange-formability of UHSS sheets. The results of this investigation revealed following conclusions. Microscopic plastic-flow or micro-void density generated by punching is not the dominant factor of the stretch-flange-formability of UHSS sheets. During hole-expanding, cracks were mainly initiated at the fractured surface part and the cracks became longer and deeper from the punched surface with the increase of hole-expanding ratio. Deep cracking resistance in this process is important to improve the stretch-flange-formability. The existence of strain gradient induced by hole punching is considered to be one of the reason for the highest hole-expanding ratio of the martensite single phase steel. During hole-expanding, the micro-cracks propagate mostly along the phase interfaces in the dual-phase steel sheets in the case of poor stretch-flange-formability, while the micro-cracks are tend to propagate through ferrite and martensite phases in the case of high stretch-flange-formability. The analysis of the hardness of ferrite and martensite suggests that the difference in hardness is the dominant factor of the stretch-flange-formability of the dual-phase steel. In addition, the volume fractions of phases also influence the formability.
No takes yet. Share an insight, caveat, or question.
Hasegawa et al. (2004) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: