Answers are grounded in this paper and cite their sources.
We present a time-dependent parametric model for reactive HiPIMS deposition of films. Specific features of HiPIMS discharges and a possible increase in the density of the reactive gas in front of the reactive gas inlets placed between the target and the substrate are considered in the model. The model makes it possible to calculate the compound fractions in two target layers and in one substrate layer, and the deposition rate of films at fixed partial pressures of the reactive and inert gas. A simplified relation for the deposition rate of films prepared using a reactive HiPIMS is presented. We used the model to simulate controlled reactive HiPIMS depositions of stoichiometric films, which were recently carried out in our laboratories with two different configurations of the inlets in front of the sputtered target. The repetition frequency was 500 Hz at the deposition-averaged target power densities of 5 Wcm −2 and 50 Wcm −2 with a pulse-averaged target power density up to 2 kWcm −2 . The pulse durations were 50 μ s and 200 μ s. Our model calculations show that the to-substrate inlet provides systematically lower compound fractions in the target surface layer and higher compound fractions in the substrate surface layer, compared with the to-target inlet. The low compound fractions in the target surface layer (being approximately 10% at the deposition-averaged target power density of 50 Wcm −2 and the pulse duration of 200 μ s) result in high deposition rates of the films produced, which are in agreement with experimental values.
No takes yet. Share an insight, caveat, or question.
Kozák et al. (2015) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: