Answers are grounded in this paper and cite their sources.
In this study, an Al–Mg–Zr alloy was developed for laser powder bed fusion (LPBF) to fulfill the need for a cost-effective, high-strength additive manufactured (AM) aluminum alloy. To get to the peak strength a single-step aging treatment (6 h at 400 °C followed by gas quench) was conducted on the printed alloy. The quasi-static uniaxial tensile properties of aged LPBF Al–Mg–Zr were measured as yield strength (YS) of 390 ± 2 MPa, ultimate tensile strength (UTS) of 428 ± 2 MPa, and elongation to failure (EL) of 14.26 ± 0.94 %. Microstructure analyses via scanning electron microscopy (SEM) and electron backscatter diffraction (EBSD) displayed the presence of precipitates and a bimodal grain distribution with ultrafine (∼1 μm) and fine grains (∼5 μm). Detailed investigation through transmission electron microscopy (TEM) showed frequent precipitation of nanoscale L1 2 -Al 3 Zr along with sub-micron Mn- and Fe-rich precipitates (i.e., orthorhombic Al 6 (Mn, Fe)) and nanoscale Mg- and O-rich particles. The work-hardening behavior of the studied LPBF Al–Mg–Zr alloy offered valuable insights into the connection between the microstructure and tensile properties. • Bimodal grains in LPBF Al–Mg–Zr alloy yield high strength and elongation (∼15 %). • TEM reveals L12-Al 3 Zr precipitates, Mn/Fe-rich phases, and Mg/O-rich nanoparticles. • Yield plateau and minimal PLC effect were observed in the stress-strain behavior of the alloy. • The controlling strengthening mechanisms of LPBF Al–Mg–Zr alloy were discussed.
No takes yet. Share an insight, caveat, or question.
Shakil et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: