Answers are grounded in this paper and cite their sources.
Context: Water pollution from synthetic dyes, particularly from the textile industry, is a critical environmental challenge. Globally, over 80% of wastewater is released untreated, representing a major pressure on freshwater resources (UNESCO, 2023). This underscores the need for low-cost, scalable adsorbents operable under mild conditions. Problem: Congo Red (CR), an anionic azo dye, is one of the persistent and potentially toxic pollutants that poses a significant threat to aquatic ecosystems. Objective: This study evaluates the performance of raw natural diatomite from the Sidi Lakhdar deposit (Algeria) as a cost-effective adsorbent for CR removal. Batch adsorption experiments were conducted under varying conditions, and the material was characterized by XRD, SEM/EDX, BET, and PZC. Equilibrium data were fitted to the Langmuir, Freundlich, Temkin, BET, and Sips models, both in their linear and non-linear forms. The kinetic data were analyzed using the pseudo-first-order, pseudo-second-order, Weber–Morris, and Boyd models. Results: Experimental data revealed a rapid uptake phase, achieving approximately 87% CR removal within 45 min and reaching a plateau thereafter. Nonlinear isotherm analysis showed high fits for both the Sips and Langmuir models. The Sips model provided a slightly better statistical fit ( R 2 ≈ 0 . 997 , RMSE ≈ 0 . 028 ) and a higher maximum capacity ( Q m ≈ 3 . 30 mg/g ). However, a comprehensive information criterion analysis (AICc and BIC) showed a strong preference for the Langmuir model ( Q m ≈ 2 . 48 mg/g ), with the Akaike weight ( w ) for Langmuir being ∼ 0 . 90 , highlighting its greater parsimony. Favorable adsorption was confirmed by the Langmuir separation factor ( R L ≈ 0 . 6423 ∼ 0 . 1522 ), with a pH drift suggesting contributions from electrostatic interactions. Kinetic analysis using AICc and Akaike weights identified the pseudo-first-order model as the most plausible, with the highest Akaike weight ( w ≈ 0 . 69 ). The pseudo-second-order model was a close second ( w ≈ 0 . 18 ), with its predicted q e (2.76 mg/g) being a bit high. This suggests the adsorption kinetics are best described by a simpler mechanism, such as physisorption or intraparticle diffusion, although a more complex chemisorption mechanism cannot be entirely ruled out. Significance: The results confirm the potential of raw natural diatomite as an effective and sustainable adsorbent, with a primary adsorption mechanism characterized by monolayer coverage on largely homogeneous sites. This minimal-processing approach supports a scalable, low-footprint solution for wastewater treatment.
No takes yet. Share an insight, caveat, or question.
Brahimi et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: