Answers are grounded in this paper and cite their sources.
Lean hydrogen combustion is becoming increasingly popular for energy systems targeting decarbonisation using hydrogen. In this work, the characteristics of a partially premixed flame in a hydrogen lean direct injection (LDI) combustor were investigated. A jet-in-crossflow configuration was used in this combustor , with the hydrogen injected inwards through two diametrically opposite holes positioned on the circumference of a circular air channel. Heat release measurements were obtained with OH* chemiluminescence using, (i) photomultiplier tube (PMT), and (ii) intensified CMOS camera, while pressure measurements were conducted with high-sensitivity dynamic pressure transducers . Effects of bulk velocity and global equivalence ratio ( ϕ g l o b a l ) on flame behaviour and acoustic characteristics were studied. The flame images showed changes in the flame lift-off height and flame length as the ϕ g l o b a l was varied from rich to lean conditions. Mixture fraction results showed that an increase in both bulk velocity and ϕ g l o b a l improved mixing which was attributed to higher momentum flux ratio. High frequency pressure oscillations were observed at the leaner and richer ϕ g l o b a l conditions for 40 m/s and only at leaner conditions for 120 m/s. The heat release oscillations were observed to be coupled to the pressure oscillations for the higher frequency modes of the combustor at 40 m/s and 120 m/s. For both velocities, the largest amplitude of oscillations occurred at the ϕ g l o b a l conditions with the lowest average flame length.
No takes yet. Share an insight, caveat, or question.
Ezenwajiaku et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: