Answers are grounded in this paper and cite their sources.
Two-photon polymerization (2PP)-based 3D printing enables the fabrication of highly complex structures, including structures that are of interest in microrobotics, such as helical microswimmers. However, the direct fabrication of structures entails long fabrication times, a limited choice of materials, and poor scalability. Although micromolding has been proposed previously, as it promises high-throughput microfabrication, approaches to date have either utilized a single-use mold, which again limits scalability, or they have thus far not shown the efficient molding and release of closed-loop geometries. Here, we present a versatile and scalable micromolding and release strategy for the rapid fabrication of 3D helical microswimmers. By integrating a membrane-assisted mold design, the developed platform enables repeated reuse of PDMS molds while expanding material compatibility. Hybrid inorganic-organic materials (polyhedral oligomeric silsesquioxane (POSS)) and hydrogel biomaterials (alginate (Alg) and gelatin (Gel)) based microswimmers were successfully micromolded by using the introduced method through photocrosslinking and ionic crosslinking strategies. The former allows the realization of hard SiO2 microstructures. Large arrays of 3D helical microswimmers were fabricated within 30 min, compared with the tens of hours typically required for 2PP printing. In addition, a thin-film-assisted lift-off approach was developed for efficient harvesting of molded microswimmers. The fabricated hydrogel microswimmers exhibited favorable biocompatibility. After magnetic functionalization, the microswimmers achieved controlled locomotion under external magnetic fields. This work establishes a scalable and material-flexible platform for high-throughput helical microswimmer fabrication.
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: