Answers are grounded in this paper and cite their sources.
While operating at low airspeeds with nominal static margins, the controls on a blended-wing-body aircraft begin to saturate, and the dynamic performance gets sluggish. Augmentation of aerodynamic controls with the propulsion system is therefore considered in this research. Two aspects were of interest: namely, thrust vectoring and flap blowing. An aerodynamic model for a large blended-wing-body transport aircraft with blown flap effects was formulated using empirical and vortex lattice methods and then integrated with a Trent 500 turbofan engine model. To enhance control effectiveness, both internally and externally blown flaps were simulated. For a full-span internally blown flap arrangement using intermediate compressor flow, the amount of engine bleed and the resulting blowing coefficients were limited. However, even with a reduced bleed mass flow, the pitch control effectiveness increases by 15.9 % at 85 % fan revolutions per minute. For an externally blown flap arrangement using bypass air, much higher blowing coefficients can be achieved. For instance, at 100 % fan revolutions per minute, there is a 44% increase in pitch control authority at low dynamic pressures. The main benefit occurs during takeoff, where both thrust vectoring and flap blowing help in achieving early pitch rotation, reducing takeoff field length and liftoff speed considerably. With central flap blowing and a limited thrust vectoring of 10, the liftoff range reduces by 48%, and liftoff speed reduces by almost 26%. Nomenclature Ajet = wing nozzle, exit area CL, CD, Cm = lift, drag, and pitch moment coefficient Cu = blowing momentum coefficient Ma = aerodynamic pitching moment about c.g. MLG = pitching moment about main landing gear _m jet = wing nozzle, jet mass flow q = dynamic pressure Vjet = wing nozzle, jet velocity x=l = bleed location (x) along compressor length (l) Xa, Xg, XE = X-body axis aero, gravity, and thrust forces Za, Zg, ZE = Z-body axis aero, gravity, and thrust forces, = angle of attack and sideslip a, e, T = aileron, elevator, and throttle position I.
No takes yet. Share an insight, caveat, or question.
James Ferris Whidborne (2010) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: