Answers are grounded in this paper and cite their sources.
: The effects of hot isostatic pressing (HIP) temperature (880 °C, 920 °C, and 960 °C) on the microstructural evolution and fatigue crack growth (FCG) behavior of electron beam melting (EBM)-fabricated Ti–6Al–4V alloy were systematically investigated. The results show that HIP treatment effectively eliminates detectable internal defects and promotes the decomposition of the martensitic α′ phase into a lamellar α + β microstructure. With increasing HIP temperature, the α lamellae, α colonies, grain-boundary α, and prior-β grains progressively coarsen. Fatigue crack growth tests revealed that the 920 °C-treated specimen exhibited the lowest crack growth rate, indicating the highest FCG resistance among the investigated conditions. The FCG behavior is strongly influenced by the scale matching between the cyclic plastic-zone size and the characteristic microstructural length scales. When these scales are comparable, strong crack–microstructure interactions induce crack deflection and fluctuations in the crack growth rate. Crystallographic analysis indicates that α lamellae with basal slip orientation are more likely to be cut nearly perpendicular by the crack, whereas lamellae favorably oriented for prismatic and pyramidal slip facilitate crack propagation along or obliquely across the lamellae. In addition, large misorientation angles and poor slip transfer capability at α/α interfaces enhance the tortuosity of the crack path. The superior crack growth resistance of the 920 °C specimen is attributed to increased crack deflection, a higher proportion of translamellar propagation, and enhanced plastic deformation capability, which collectively contribute to the retardation of crack growth.
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: