Answers are grounded in this paper and cite their sources.
Proton exchange membrane fuel cells (PEMFCs) are an important technology in the ongoing effort to reduce the carbon intensity of transportation, of which bipolar plates (BPPs) are a major component. As compared to graphite and composite BPPs, metallic bipolar plates provide superior mechanical and physical properties but will require innovative solutions to decrease interfacial contact resistance (ICR) and increase corrosion resistance. The goal of this study was to use high-power impulse magnetron sputtering (HiPIMS) with cathode reversal to manipulate the properties of carbon coatings to get low ICR and high corrosion resistance for 316L stainless steel BPPs. It was observed that ICR decreases with decreasing substrate thickness. Therefore, specifying substrate thickness for metallic bipolar plate research is recommended here, for the first time to our knowledge. ICR decreased with increasing cathode reversal voltage. Finally, ICR decreased with increased negative pulse peak current, which was varied by changing the pulse repetition rate. An ICR of 7.6 mΩ-cm 2 was achieved. C film density increased with both increased cathode reversal voltage and increased negative pulse peak current, reaching a maximum of 2.2 g/cm 3 , showing higher film density decreases ICR. Corrosion stability tests revealed that the stainless steel substrates with denser C coatings could better withstand both anodic (3 × 10 −5 A/cm 2 ) and cathodic (1.7 × 10 −7 A/cm 2 ) corrosion environments as compared to those with a lower density C coating. This study demonstrates that very thin (200 nm) and amorphous C coatings with high density can have excellent performance for BPP protection applications in PEMFCs and beyond.
No takes yet. Share an insight, caveat, or question.
Connolly et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: