Answers are grounded in this paper and cite their sources.
Reliable link switching in high-speed Serial RapidIO (SRIO) systems requires the standby channel to remain aligned with the active channel before a fault occurs. This paper presents an FPGA-based dual-redundant SRIO transmission method that combines active-standby hot backup, dual-layer cyclic redundancy check (CRC) alignment, and immediate link switching. Two independent SRIO channels and dedicated buffer memories are implemented in the FPGA. A CRC is calculated for each packet, and a second CRC is generated from the CRC values of 32 consecutive packets. Parallel comparison of the two channels’ CRC register sets identifies their address offset, allowing the standby read pointer to be updated continuously. When the active link becomes invalid, the output switches directly to the aligned standby channel without waiting for a fault counter. Experiments at 2.5 Gbps comprised 1000 test runs, each involving continuous data transmission, recording of the received results, and one manually induced interruption-recovery cycle. Following disconnection of the active link, the frame sequence remained continuous with no lost or duplicate frames. These results show that the proposed method can maintain data continuity during link interruption and recovery under the tested conditions.
No takes yet. Share an insight, caveat, or question.
Xue et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: