Answers are grounded in this paper and cite their sources.
Martensitic stainless steels are widely used in cutting tools, pumps, turbine shafts, and kitchen equipment due to their high hardness, strength, and corrosion resistance; however, their high carbon content makes them difficult to weld. This study investigates the weldability of AISI 420 J2 martensitic stainless steel using low-heat-input laser welding, both in the as-welded condition and with post-weld stress-relief heat treatment. Laser welding was performed at a peak power of 1000 W and a welding speed of 3.77 mm/s, resulting in full-penetration welds. The specimens were subjected to hardening at 1000°C for 30 min followed by air cooling, while stress-relief annealing was performed at 650°C for 75 min followed by slow furnace cooling. The mechanical properties were evaluated through tensile and Vickers microhardness tests, while microstructural characterisation was performed using optical microscopy. The results showed that full penetration welds could be successfully obtained; however, cracks and damage were observed in the weld zone in the as-welded condition. After stress-relief annealing, no cracks were observed in the examined weld regions, and failure shifted towards the base material. The base material exhibited yield and tensile strengths of 1226 MPa and 1491 MPa, respectively, after heat treatment, while welded and air-cooled specimens showed significantly reduced values of 520 MPa and 674 MPa. Microhardness values varied depending on processing conditions, reaching approximately 550–700 HV0.2 in the weld zone and 200–390 HV0.2 in the base material. Overall, under the experimental conditions investigated, stress-relief annealing improved the weld-zone integrity and shifted tensile failure from the weld region towards the base material.
No takes yet. Share an insight, caveat, or question.
Korkmaz et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: