Answers are grounded in this paper and cite their sources.
The behaviour of precast concrete segmental bridges (PCSBs) fundamentally depends on the joints, which represent discontinuity zones and must be capable of transmitting combined forces (axial, bending and shear) between segments. Under service conditions, joints in PCSBs are expected to remain in full contact, although partial opening may occur under ultimate load conditions. Castellated dry joints with external prestressing are increasingly used due to their efficient construction, environmental advantages and adequate mechanical interlock. Although numerous experimental and numerical studies have investigated their shear behaviour and capacity, studies under combined forces are very limited. The test configuration developed by the authors allows the shear behaviour of the joints to be investigated independently of the global behaviour of the segmental beams. This paper presents 22 push-off tests, 17 from the present experimental programme and 5 from previous studies conducted by the authors, on specimens with three-keyed dry joints made of different concrete types and fibre contents, subjected to varying axial forces and eccentricities. The influence of these variable parameters on cracking patterns and shear capacity was studied. In addition, the results obtained under eccentric loading were compared with those from specimens subjected to uniform confining stress, which showed shear capacities up to 49% higher than those under eccentric loading. Finally, the accuracy of the AASHTO and Fouré et al. formulations for predicting shear strength under combined loading was evaluated for different concrete types, with and without steel fibres.
No takes yet. Share an insight, caveat, or question.
Traver-Abella et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: