Answers are grounded in this paper and cite their sources.
Natural ferric oxide (NFO), a hematite (α-Fe 2 O 3 ) mineral from the Chaabet El-Ballout deposit (Aïn Zana, Algeria), was evaluated as a low-cost adsorbent for the removal of Ethyl green (EG) dye from aqueous solutions. The adsorbent was characterized by X-ray diffraction, N 2 adsorption–desorption and point of zero charge measurements, exhibiting a BET surface area of 70.25 m 2 g −1 , a total pore volume of 0.085 cm 3 g −1 and a pH pzc of 7.27. The influence of initial dye concentration (15–35 mg L −1 ), adsorbent dose (0.5–1.5 g) and solution pH (5.3–9.3) on removal efficiency was investigated. Adsorption was rapid, reaching equilibrium within 120 min, and was favored at alkaline pH and elevated temperature. Kinetics followed the pseudo-second-order model (R 2 > 0.99), and equilibrium data were best described by the Langmuir isotherm, giving a maximum adsorption capacity of 31.61 mg g −1 (R 2 = 0.9844). A Box–Behnken design coupled with response surface methodology yielded a highly significant quadratic model ( F = 30.34, p = 0.001, R 2 = 0.9820), with pH identified as the most influential parameter. Numerical optimization predicted near-complete removal at C 0 = 15 mg L −1 , adsorbent dose = 1.3 g and pH = 8.2; experimental validation under these conditions achieved 98.5 % removal within 30 min and complete removal (100 %) after 45 min. These findings demonstrate that NFO is a promising, sustainable and low-cost adsorbent for the removal of cationic dyes from wastewater.
No takes yet. Share an insight, caveat, or question.
Bousnoubra et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: