Answers are grounded in this paper and cite their sources.
Programming multiple deformation modes within a continuous liquid crystal elastomer (LCE) filament remains challenging because molecular alignment and active‐material distribution are typically coupled to the external printing path. Here, a rotational multimaterial printing strategy is introduced that encodes two co‐curable LCE phases with opposite free thermal strains within individual fibers. These antagonistic free strains act cooperatively after co‐curing to generate internal strain mismatch and structural deformation. A dual‐channel rotating nozzle co‐extrudes a thermally contracting nematic LCE and a thermally elongating smectic LCE, while nozzle angle, angular velocity, and flow‐rate ratio prescribe their cross‐sectional and axial distributions. Discrete and continuous rotation enable contraction, elongation, in‐plane bending, out‐of‐plane curling, and helical coiling without changing the filament centerline. Under matched conditions, the active–active fibers exhibit an approximately 1.6‐fold increase in curvature relative to the active–passive controls, while simultaneous co‐curing increases interfacial peel strength by approximately 30 times that achieved by sequential curing. The same encoding strategy extends from individual fibers to grids and Gaussian‐curvature surfaces and enables force‐generating strips, thermal protection, self‐sensing, particle sorting, and adaptive gripping. Rotational multimaterial printing therefore decouples intra‐filament architecture from toolpath geometry and provides a general route to spatially programmable active fibers.
No takes yet. Share an insight, caveat, or question.
Sun et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: