Answers are grounded in this paper and cite their sources.
Proton exchange membrane (PEM) water electrolysis is a key technology for sustainable hydrogen production but relies on scarce and expensive iridium-based oxygen evolution reaction (OER) catalysts. Consequently, efforts focus on reducing iridium loading including partial substitution with alternative materials and thin-film fabrication strategies for ionomer-free catalyst layers. is a promising alternative because of its high intrinsic activity and lower material cost, however, its long-term stability remains challenging and structure–performance relationships are not fully understood. Here, reactive magnetron sputtering is used to fabricate ionomer-free OER catalysts as porous transport electrodes. By systematically varying deposition parameters, the films’ nanostructure was tuned over a wide grain-size range. Smaller grains were found to increase the electrochemically active surface area (ECSA), thereby enhancing OER performance in three-electrode and PEM electrolyzer tests. Electrochemical impedance spectroscopy combined with X-ray photoelectron spectroscopy suggests that the increased ECSA is enabled by proton-conductive hydrated grain boundaries. Smaller grains also improve long-term stability: an optimized electrode with 0.64 mg cm −2 loading operated for > 700 h at 1 A cm −2 , including > 300 h with a degradation rate of only 4 μV h −1 . These findings demonstrate that controlling the nanostructure of sputtered can enable efficient, durable, and scalable ionomer-free OER catalysts for PEM water electrolysis.
No takes yet. Share an insight, caveat, or question.
Krammer et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: