Answers are grounded in this paper and cite their sources.
Commercial sodium-ion batteries (SIBs) are entering the market, increasing the need to understand how cell design and chemistry influence degradation. This single sample case study combines teardown, electrochemical testing and post mortem analyses of three commercial 18650 cells: NaNi 1/3 Fe 1/3 Mn 1/3 O 2 (NFM)||hard carbon (HC) cells NFM-1200 and NFM-1500, and a Na 3 V 2 (PO 4 ) 2 F 3 (NVPF)||HC cell (NVPF-700), named according to manufacturer-specified nominal capacities (mAh). Among the investigated cells, NFM-1500 had the highest cathode loading, areal capacity and cell-level energy density. During long-term cycling, NFM-1500 reached 80% of its initial discharge capacity after approximately 500 cycles, whereas NFM-1200 underwent greater relative capacity loss over extended cycling. NVPF-700 retained approximately 600 mAh after 3000 cycles (97% of its initial 1C discharge capacity, approximately 620 mAh). For the individual cells investigated, higher rate capability was observed for the NFM-based cells compared to NVPF-700. Post mortem analyses revealed pronounced electrolyte decomposition and Ni/Mn/Fe deposition on HC in NFM-1500. In NVPF-700, a mixed NaPF 6 /NaFSI electrolyte with additives (succinonitrile, VC, FEC, BF 4 − and DFP) and V deposition on HC were identified. Different degradation rankings under long-term cycling and C-Rate testing revealed that observed aging depends on active material chemistry, electrode loading, morphology, electrolyte formulation and cycling protocol, with cell-to-cell variability remaining a potential factor.
No takes yet. Share an insight, caveat, or question.
Fehlings et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: