Answers are grounded in this paper and cite their sources.
Quantification of machinability is challenging, especially with the development of new materials like DC 53 steel and new tooling, such as the fabrication of indexable inserts. In this context, an integrated machining performance framework named the Integrated Hole Integrity Index (IHII) is proposed. An indexable drilling setup with peripheral wiper inserts and central stepped carbide inserts was employed. The drilling tests were conducted at 20 m/min and 30 m/min cutting speeds while employing feed rates of 0.05 mm/rev, 0.075 mm/rev, and 0.10 mm/rev to assess the effect of microstructure on tool wear, surface integrity, diametric error, machining temperature, and burr formation. The microstructural examination revealed that D2 steel contained large carbides that were not evenly distributed, but DC53 steel displayed a martensitic structure with small carbides that were evenly spaced. The D2 steel performed better than DC53 steel such that the minimum flank wear value of 49 μm was recorded when drilling the former material at 20 m/min and 0.05 mm/rev, with surface roughness values being in the range of 1.0–4.8 μm. However, tool wear was almost in the same vicinity, but roughness values were substantially higher, ranging from 1.9 to 5.4 μm with the latter material at the same machining parameters. The SEM analysis revealed that surface damage occurred through three main mechanisms, which included adhesion, material side flow, and plastic deformation. For a more holistic drilling performance assessment, an IHII model/performance metric is calculated using entropy weights and subsequently TOPSIS analysis was conducted to overcome the limitations of individual output responses. Hereafter, the best drilling condition is suggested, which indicates the best compromise among all output responses. A value of 0.743 for IHII was calculated for Test 4, performed on D2 material, showing a better performance index, while a 23% lower IHII was determined for DC53 steel.
No takes yet. Share an insight, caveat, or question.
Ijaz et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: