Answers are grounded in this paper and cite their sources.
Three-dimensional Perlite-based monolithic adsorbents with different Perlite loadings (3D-Per5, 3D-Per10, and 3D-Per15) were fabricated via digital light processing (DLP) 3D printing for methylene blue (MB) removal from aqueous solutions. The influence of Perlite loading on adsorption performance was systematically investigated, with 3D-Per15 exhibiting the highest adsorption capacity. To further improve its performance, the optimized monolith was subjected to acid treatment, which removed surface impurities, increased the exposure of accessible adsorption sites, and enhanced pore accessibility, thereby significantly promoting dye adsorption while preserving the structural integrity of the printed monolith. The adsorption behavior was evaluated under different operating conditions. The highest MB removal efficiency of 89% and a maximum adsorption capacity of 17.8 mg g − 1 were achieved at pH = 10 and 85°C after 100 min. Kinetic analysis yielded an activation energy of 27.14 kJ mol − 1 , while thermodynamic parameters confirmed that the adsorption process was endothermic (ΔH = 24.36 kJ mol − 1 ) with a negative entropy change (ΔS = − 179.91 J mol − 1 K − 1 ). These findings demonstrate that integrating DLP 3D printing with post-print acid activation is a simple and effective strategy for developing high-performance monolithic adsorbents for wastewater treatment.
No takes yet. Share an insight, caveat, or question.
Ranjbar et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: