Answers are grounded in this paper and cite their sources.
Under the comprehensive effect of high thermal load, thermal stress, and mechanical stress, the cylinder head may experience several risks, such as cracking and failure, compromising the safety and durability of diesel engine operation. Due to the uneven heat source distribution in a cylinder head, the thermal boundary conditions in different zones of the gas side or cooling water side cannot be precisely calculated using empirical or semi-empirical formulas. This study proposes a complete analysis framework that integrates diesel engine performance experimental testing with numerical simulations to evaluate thermal loads, thermo-mechanical coupling stress fields, and fatigue life in a marine diesel engine cylinder head. Based on the diesel performance experiment data, calibrated simulation models of the cylinder head were developed, including a one-dimensional diesel working process simulation, three-dimensional diesel intake–exhaust and combustion simulation, and a gas–liquid–solid three-phase flow boiling heat transfer model. Direct and sequential coupling methods were used to simulate gas–solid–liquid coupling in the cylinder head, avoiding the need for thermal boundary assumptions across different zones. A user-defined function was programmed to embed the single-phase-flow BDL boiling model into the fluid–solid coupling heat transfer calculation of the cylinder head, and the influence of boiling factors on heat transfer was analyzed. The results show that the gas–solid–liquid multi-field coupling simulation system effectively reflects the complex heat transfer process in the cylinder head. Under rated and maximum torque conditions, the maximum temperature of the cylinder head reached 608 and 618 K, respectively, in the bridge region between the two exhaust valves, followed by the injector hole region at approximately 580 K. High temperatures of the inner water jacket, located at the edges of the exhaust valve and injector hole, and the outer water jacket, located at the edge of the exhaust valve, are prone to local subcooled nucleate boiling and are therefore identified as critical regions for thermal fatigue management of the cylinder head. Thermal stress is the main factor affecting the extreme value and distribution of thermo-mechanical coupling stress. The maximum value of the coupling stress was concentrated in the area of the exhaust valve seat facing the injector hole and the surrounding area of the injector hole, reaching approximately 320 MPa. Under the high-cycle fatigue analysis, most regions of the cylinder head exhibited fatigue lives of approximately 107 cycles, whereas the lowest predicted fatigue lives were concentrated around the injector hole, in the exhaust valve area facing the injector hole, and in the bridge area between the two exhaust valves. Because these regions also experience the highest temperatures and thermo-mechanical stresses, they are identified as potentially susceptible to thermal–mechanical fatigue damage and should be prioritized in cooling system optimization.
No takes yet. Share an insight, caveat, or question.
Zhang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: