Answers are grounded in this paper and cite their sources.
The initial stage of sugarcane breeding involves evaluating seedlings derived from biparental or polycrosses, which are subsequently assessed through vegetative propagation. In this context, the use of high-density planting may enable evaluation of more plants per family or more families within smaller areas, thereby optimizing experimental area and resources during the early stages of the breeding program. This study aimed to evaluate the performance of sugarcane genotypes selected within families under a high-density planting (HDP) system during the initial phase of genetic improvement. Two experiments were conducted at the Sugarcane Research Center of the Federal University of Viçosa. In Experiment I, 98 half-sib families were evaluated in a randomized block design with planting densities of 0.12 m within rows and 1.40 m between rows. Families were ranked based on average values of total soluble solids (Brix) and tons of cane per hectare (TCH). The ten highest-performing and ten lowest-performing families for each trait were identified. Due to overlap between groups, 34 families were ultimately selected. In Experiment II, the two most vigorous stalks per plot from these 34 families were evaluated using an augmented block design. The results showed that family classification was more consistent between experiments for Brix than for TCH. Chi-square tests confirmed a significant association between family classification in Experiment I and individual performance in Experiment II for both characteristics. Individuals selected within superior families under an HDP system maintained their performance in subsequent evaluations, contributing to more efficient resource use and optimizing the evaluation of large populations in limited areas during the early stages of sugarcane breeding.
No takes yet. Share an insight, caveat, or question.
Silva et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: