Answers are grounded in this paper and cite their sources.
This study investigates the influence of selected commercially available lubricants on the tribological behaviour of quenched and tempered 42CrMo4 steel intended for highly loaded mechanical and firearm components. Ten oils available on the domestic market were selected according to their ability to reduce friction, protect metallic surfaces and avoid silicone or PTFE-based additives. Reciprocating Ball-on-flat tests were performed using a Bruker UMT TriboLab with a G40 steel ball under a normal load of 50 N, a stroke length of 10 mm, a sliding speed of 0.3 m/min and a test duration of 20 min. The worn surfaces were evaluated using a LEXT OLS5100 3D laser confocal microscope. The dry reference sample reached the highest coefficient of friction, μ = 0.548, and the highest wear volume, 0.11127 mm³. In contrast, all lubricated samples showed substantially lower friction values, μ = 0.102–0.131, and wear volumes of 0.00264–0.00491 mm³. The best performance was achieved by BRUNOX® LUB&COR®, which provided the lowest friction coefficient and wear volume. Morphological analysis revealed severe adhesive and abrasive wear under dry conditions, whereas lubricated surfaces exhibited reduced damage and protective tribo-oxidative layers. The results confirm that lubricant viscosity, film stability and surface interactions significantly affect friction and wear of 42CrMo4 steel.
No takes yet. Share an insight, caveat, or question.
Kuffova et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: