Answers are grounded in this paper and cite their sources.
This experimental work investigates the formability improvement of peak tempered AA7075-T6 and AA6061-T6 sheets during the novel electric hot forming in-die quenching (EHFQ) process. Unlike the conventional HFQ®, the blank was placed directly within the forming station, rapidly resistance heated to 470 °C using an alternating current electric injection, and soaked at this temperature for 10 minutes. Limiting dome height (LDH) tests were performed at punch speeds of 10 and 36 mm/min to generate the forming limiting curves (FLCs) along plane strain to near-to-uniaxial strain paths. The EHFQ process significantly increased the LDHs, improved thickness and strain distribution patterns, and overall formability. The FLC 0 increased by approximately 100% and 70.6% for AA7075 and AA6061, respectively, when compared to room temperature (RT). Even though bending-corrected-FLCs exhibited a marginal downward shift, the significant improvement in formability was evident. Scanning electron microscopy (SEM) and Energy dispersive X-ray spectroscopy (EDS) analyses indicated the dissolution of strengthening precipitates during the electro-thermal pre-heating stage. The Vickers hardness was reduced by 34.8% and 49.15% for AA7075 and AA6061, respectively, compared to that at RT. The SEM fractography revealed a higher density of shallow and deep dimples, hinting enhanced ductile fracture behavior, resulting in enhanced stretch formability especially for EHFQ at 36 mm/min. A post-forming heat-treatment substantially recovered the precipitation hardening with hardness nearing to the alloy-specific T6 temper. Overall, the combined benefits of improved formability and recovery of precipitation hardening favored AA7075 compared to AA6061.
No takes yet. Share an insight, caveat, or question.
Rao et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: