Answers are grounded in this paper and cite their sources.
For large-area substrate-to-base-plate joints in power modules, low-temperature Cu particle sinter bonding can offer a low-cost and high-thermal-conductivity alternative to soldering. Studies on large-area, low-temperature Cu sinter bonding remain scarce. In this study, ultrafine dendritic Cu particles were synthesized via a wet-chemical route and formulated into a Cu paste using a reducing vehicle. This paste was used for large-area (12 mm × 12 mm) pressure-assisted sinter bonding at 220 °C in air. The filler exhibited a median particle diameter of 4.68 μm and a Brunauer–Emmett–Teller surface area of 9.36 m2/g, reflecting a hierarchical architecture with nanogranule-decorated branches. Large-area joints achieved shear strengths of 35.1 and 70.6 MPa (at 15 MPa for 1 and 10 min) and 59.4 MPa (at 10 MPa for 5 min), surpassing small-area counterparts (3 mm × 3 mm) and reported large-area values. This high performance stems from rapid interfacial necking and <10% bond-line porosity within 3 min. Spatially resolved shear testing and scanning acoustic tomography identified edge-localized voiding and oxidation as dominant causes of reduced peripheral strength. These findings suggest that dendritic Cu pastes exhibit considerable potential as a low-cost, agglomeration-resistant option for low-temperature, large-area die attachment applications in power modules.
No takes yet. Share an insight, caveat, or question.
Oh et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: