Answers are grounded in this paper and cite their sources.
Lead-free epoxy composites containing 0–35 vol % bismuth oxide (Bi2O3) were fabricated by direct ink writing. The inks contained Epon 826, 2-ethyl-4-methylimidazole, and fumed silica. Density, Vickers hardness, optical microstructure, dimensional fidelity, and photon attenuation were evaluated using 57Co, 137Cs, and 60Co gamma sources. Measured density increased from 1.09 ± 0.03 g cm–3 for the unfilled epoxy to 3.840 ± 0.009 g cm–3 at 35 vol % Bi2O3. Attenuation increased most strongly at 122 keV. Print records showed that the 30 vol % formulation extruded at a flow multiplier of 1 without a reported printing failure, whereas the 35 vol % ink became too thick to extrude during one run. The 30 vol % formulation was therefore selected for a fitted prototype plate. The installed plate demonstrates fabrication and fit; postinstallation leakage attenuation was not measured.
No takes yet. Share an insight, caveat, or question.
Mondal et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: