Answers are grounded in this paper and cite their sources.
Emulsified asphalt-based fog seals are widely used for the preventive maintenance of airport asphalt pavements. Compared with highway pavements, airport runways and taxiways operate under far more demanding conditions: wide-body aircraft exert tire pressures of 1.2–1.6 MPa while undergoing extreme acceleration during takeoff and severe deceleration during landing, generating coupled vertical compression and horizontal shear forces that conventional single-modifier emulsified asphalts cannot reliably withstand. Surface degradation at airports also carries direct flight-safety consequences—raveled aggregate becomes foreign object debris (FOD), and loss of surface texture compromises braking friction—making high-performance preventive maintenance materials far more critical for airports than for highways. This study develops a waterborne epoxy resin (WER)–styrene-butadiene rubber (SBR) composite modified emulsified asphalt integrating high toughness, ultraviolet (UV) aging resistance, and Wettability to meet these stringent airport requirements. Fluorescence microscopy reveals that the polymer undergoes dense polymerization and continuous changes, which may construct an interpenetrating polymer network (IPN); the optimal WER content for network integrity is 15%. An L16(44) orthogonal experiment is designed with WER content, solid content, UV absorber content, and hydrophobic agent content as factors and bond strength, viscosity aging index, and contact angle as responses. Range analysis shows that WER dominates bond strength, UV absorber dominates aging resistance, and hydrophobic agent dominates Wettability, confirming conflicting single-objective optima. A three-layer matrix analysis method is applied for multi-objective collaborative optimization, yielding the optimal formulation: WER 15%, solid content 50%, UV absorber 0.6%, and hydrophobic agent 5%. Performance verification demonstrates that the designed formulation achieves a softening point of 66.7 °C and a ductility of 585 cm. Dynamic shear rheometer (DSR) tests show that at 52 °C the rutting factor is 14.3% higher than SBR-modified asphalt and 150.2% higher than ordinary asphalt. Bending beam rheometer (BBR) tests at −18 °C reveal that the creep stiffness S is only 73.6% of SBR-modified asphalt, while the creep rate m is 40.2% higher than ordinary asphalt, satisfying SHRP specifications. The storage stability of Component A meets specification requirements. The proposed WER–SBR composite modified emulsified asphalt provides a high-performance binder for multifunctional sand-containing fog seals, addressing the unique coupled load–shear–environment demands of airport pavement preventive maintenance.
No takes yet. Share an insight, caveat, or question.
Ruan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: