Answers are grounded in this paper and cite their sources.
Adding ferrotitanium, graphite or pre-formed TiC to a hardfacing consumable is expected to raise coating hardness, but the literature does not say by how much. We assembled a dataset of 275 records from 45 publications (2006–2026) on in situ TiC-reinforced Fe-based coatings and estimated the precursor effect with a linear mixed-effects model carrying a random intercept per study. Within a study, the lowest-to-highest precursor step raised hardness by a factor of 1.73 (95% CI 1.50–2.01) weighted by measurements, or 1.50 (IQR 1.18–2.06) weighting studies equally; nine sensitivity analyses kept the central value between 1.23 and 1.93. The estimate is a range-normalised within-study contrast over ten studies, six of them laser cladding, and is the order of the available gain rather than a universal coefficient. Half the variance in log hardness lay between studies (ICC = 0.51); a pooled model reached R2 = 0.57 under random cross-validation but −0.20 under leave-study-out validation, and data-repair strategies did not change this. Equilibrium CALPHAD calculations on 156 nominal compositions gave a within-study slope of ×1.09 in hardness per 10 vol.% of equilibrium TiC, consistent, as an order-of-magnitude check, with the observed gain, while measured carbide fractions reached only 0.08–0.79 of the equilibrium ceiling. Archard harmonisation converted 58 of 72 wear values, from six of the twelve wear studies, to a specific wear rate, which fell about tenfold within a study but spanned 3.8 decades between test regimes. A six-item reporting set is proposed to make future studies poolable.
No takes yet. Share an insight, caveat, or question.
Kaptanoğlu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: