Answers are grounded in this paper and cite their sources.
Vertical tire–road forces on rough rural roads govern road holding, component loading and pavement damage. This study examines a 1.25-ton two-axle light truck whose rear leaf springs were replaced by an electronically controlled air suspension (ECAS) with PID height control, a retrofit used for agricultural transport on degraded rural roads in the Mekong Delta. A spatial multibody model with a GENSYS-type air spring was built in MATLAB/Simulink and used to compare the original and the modified truck on ISO 8608 road classes A–F at 20–100 km/h and three payloads, with the peak vertical wheel force F zmax as the main index. The deterministic comparison was complemented by ten independent road realisations per case, a sensitivity study of the PID gains and of height-sensor noise, and pavement-loading indices, and the model was compared with road measurements on the modified truck. The ECAS lowered the peak rear wheel force in every simulated case, by up to 21.1% at no load and 19.5% at half load on rough roads (classes E and F) but by at most 8.2% at full load; the front axle, whose suspension was not changed, gained at most 7.2%. Over ten road realisations the RMS wheel force varied by at most 3.3% (coefficient of variation), whereas the peak force varied by up to 14%, so reductions smaller than about 2% are within the scatter between realisations. Changing all PID gains by factors from 0 to 100, or adding height-sensor noise, changed the rear wheel force by less than 0.001%. The reduction of dynamic wheel load therefore comes from the passive characteristics of the air-spring suspension, while the PID loop performs slow levelling. For light trucks, the benefit of an air-suspension retrofit is concentrated in low-payload operation on rough roads.
No takes yet. Share an insight, caveat, or question.
Tan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: