Answers are grounded in this paper and cite their sources.
42CrMo steel is widely used in heavy machinery and other demanding applications owing to its high strength and toughness. However, its relatively poor surface wear resistance and friction properties limit its wider applications. To address this issue, tin bronze layers were deposited on 42CrMo substrates using wire arc additive manufacturing (WAAM). This study investigates the influence of overlap rate on the microstructural evolution and mechanical properties of the tin bronze/42CrMo structure. A defect-free metallurgical bond was achieved at the tin bronze/42CrMo interface under optimized conditions. The microstructure of deposited layer is dominated by α-Cu solid solution and δ phase, exhibiting a dendritic microstructure. Increasing the overlap rate enlarges the remelted zone, increases dendrite density, and enhances elemental interdiffusion across the interface, thereby improving interfacial bonding. At a 40% overlap rate, the deposited layer achieved an average microhardness of 122.7 HV, a low friction coefficient of 0.2517, and a shear strength of 382 MPa, while its wear mass loss rate was only 0.0100 mg/min, which is significantly lower than that of the bare steel substrate.
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: