Answers are grounded in this paper and cite their sources.
Metal halide perovskites are promising candidates for next-generation photodetectors due to their excellent optoelectronic properties and compatibility with flexible applications. However, their intrinsic brittleness and defect-prone grain boundaries limit the mechanical durability and long-term performance. Additive engineering offers a feasible route to simultaneously improve the performance and stability, yet the influence of molecular size for additives in flexible devices has not been systematically explored. Here, we investigate three carbonyl-based urea derivatives with increasing steric hindrance, viz. urea, 1,3-diphenylurea (1-3D), and 1,3-bis[4-(trifluoromethyl)-phenyl]urea (1–3BP), as additives in a flexible, inverted perovskite photodetector. We found that the small urea additive distributes more uniformly within the perovskite film and yields the most improved film quality and significantly reduced Young’s modulus. The bulky additives, although with more functionalities, tend to act on the bottom region of the perovskite film with slight optimization. The urea-modified device optimizes both the optoelectronic response and mechanical toughness, showing a dark current level of (4.2 ± 1.1) × 10–10 A·cm–2 and a specific detectivity of (1.87 ± 0.25) × 1013 Jones. By comparing with other literature, the flexible photodetectors we prepared exhibited higher responsivity and detectivity. After 800 bending cycles, ∼86% of the detectivity is retained for high-quality photoplethysmography (PPG) signal monitoring, demonstrating application potential in biomedical wearable devices.
No takes yet. Share an insight, caveat, or question.
Ning et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: