Answers are grounded in this paper and cite their sources.
Material extrusion (MEX) enables additive manufacturing of functional components from polyether ether ketone (PEEK). Given PEEK’s high cost, reintegrating production waste into the process chain is economically important. This study investigates PEEK filament production from virgin and recycled feedstock on a single-screw filament line. Following an analysis of process instabilities, the extruder screw, filament cooling system and die geometry were modified. Computational fluid dynamics (CFD) was used to evaluate 44 die variants; seven were manufactured and experimentally validated. At the measured mass flow rates, simulated pressure drops strongly correlated with measured melt pressures (r = 0.997). Simulations exceeded measured values by 3–10% for the 2.0 mm dies and by 48% for the 3.0 mm die. Forced-convection air cooling reduced the filament temperature at the guide rollers by 70–100 K and decreased ovality from 9.4% to 1.5%. Over 5 h of production, all diameter readings of the virgin-material filament remained within ±0.05 mm; after seven extrusion passes, 98% met this tolerance. Regrind from additively manufactured parts, likely owing to its flake-like particle geometry, yielded filament that missed the tolerance criterion. Tensile testing of low-crystallinity MEX specimens revealed no significant differences between virgin material and material extruded seven times.
No takes yet. Share an insight, caveat, or question.
Nowka et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: