Answers are grounded in this paper and cite their sources.
The growing demand for durable and sustainable construction materials has intensified research on alkali-activated binders as low-carbon alternatives to portland cement. One-part geopolymers offer practical advantages for field application; however, their long-term durability is strongly influenced by admixture compatibility, particularly superplasticizers, which can alter pore structure and chemical stability. This study investigates the influence of sulfonated naphthalene formaldehyde (SNF) and polycarboxylate ether (PCE) superplasticizers on the durability of a ternary one-part geopolymer system formulated from ground granulated blast-furnace slag, diatomite, and feldspar. Three mortar mixes were prepared: M1-N (1% SNF), M2-P (1% PCE), and M3-C (control without superplasticizer). Durability performance was assessed through acid resistance, sulfate resistance, water absorption, rapid chloride permeability test (RCPT), rapid chloride migration test (RCMT), and oxygen permeability. Microstructural analyses were conducted through X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), and scanning electron microscopy (SEM). The SNF-modified mix exhibited the lowest water absorption (3.39%), lowest RCPT charge passed (970 C), and the lowest chloride migration coefficient ( 2.65 × 10 – 12 m 2 / s ), indicating a refined and less connected pore structure. It also achieved the highest oxygen permeability index (9.51), representing an improvement of approximately 11% and 20% compared with the control and PCE-modified mixes, respectively. Under sulfuric acid exposure, the SNF-modified system showed the lowest mass loss after 180 days (1.39%) and the highest residual compressive strength, retaining about 48% of its unexposed 28-day strength, compared with 44% for the PCE-modified mix and 41% for the control. Acid exposure caused more severe deterioration than sulfate attack across all mixes, although the SNF-modified system demonstrated significantly better resistance in both conditions. XRD and FTIR analyses revealed reduced amorphous gel dissolution and limited secondary salt formation in SNF mixes, consistent with SEM observations of a compact matrix. Overall, SNF at 1% by binder mass significantly improved the durability of one-part geopolymer mortars, highlighting the critical role of superplasticizer selection in designing durable alkali-activated materials.
No takes yet. Share an insight, caveat, or question.
Poojalakshmi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: