Answers are grounded in this paper and cite their sources.
Inerter-based passive suspensions promise better ride comfort and road holding without active control, but their benefit depends on the network topology and on how the inerter is tuned. Four passive networks—a spring–damper baseline, a parallel inerter, a series tuned inerter damper (TID) and a two-branch network—are compared in a consistently parameterized passenger-car quarter-car model. Exact Root Mean Square (RMS) indices under ISO 8608 excitation are obtained from the Lyapunov equation, all networks are tuned with the same bounded optimization, and comfort–road-holding Pareto fronts are reported. Untuned inerters with typical literature values increased the RMS body acceleration by 56–105% when compared against the spring–damper baseline. Once tuned, at a static stiffness of 16 kN/m, the TID-based networks reduced it by 3.3% without loss of road holding. When road holding is relaxed to yield optimal comfort, RMS body acceleration is reduced by up to 9.1% (TID) and 16.8% (two-branch). The benefit grows with static stiffness: at 80 kN/m, the TID reduced body acceleration by 11.9% and dynamic tire load by 8.4% simultaneously. Two practical aspects are also quantified: a point-contact tire model overestimates the peak tire force on short obstacles by about 44% compared with a contact-patch filter, and the reflected rotor inertia of electromagnetic dampers must stay below about 9 kg for the adopted passenger-car parameters (16 kN/m) to avoid degrading comfort. Proper tuning, rather than the mere presence of an inerter, determines the benefit.
No takes yet. Share an insight, caveat, or question.
Esteban et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: