Answers are grounded in this paper and cite their sources.
Flexible thermoelectric fibers for wearable applications require balanced electrical performance, mechanical deformability, and continuous processability. Here, MWCNT/PEDOT:PSS composite fibers were fabricated by wet spinning followed by H2SO4 post-treatment. High-shear fibers exhibited an oriented surface texture and scattering anisotropy, while acid treatment reduced PSS-related spectral contributions. Compared with the low-shear samples, high-shear processing increased electrical conductivity and power factor (PF) by 41.5% and 47.6%, respectively. A loading of 20 wt % MWCNTs was selected by considering thermoelectric performance, spinning continuity, and tensile deformability, yielding fibers with a tensile strength of approximately 250 MPa and a fracture strain of approximately 12%. Electrical conductivity reached 1364.2 S·cm–1 after 3 h of acid treatment, whereas the 2 h treatment produced a Seebeck coefficient of 14.1 μV·K–1 and a PF of 21.2 μW·m–1·K–2. Measurements over 1000 bending cycles and 30 days of exposure to air showed modest conductivity changes and relatively stable Seebeck coefficients. The devices demonstrated temperature sensing, respiratory monitoring, and joint-motion monitoring, with a thermal response time of approximately 1.2 s and wrist-mounted open-circuit voltages of approximately 0.33–0.34 mV. A time-division multiplexing (TDM) strategy using alternating zero-current and constant-current measurements provided separate thermoelectric-voltage and resistance-response channels. These results demonstrate a route to flexible thermoelectric fibers that integrate continuous processability, mechanical deformability, and multimodal wearable sensing.
No takes yet. Share an insight, caveat, or question.
Qin et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: