Answers are grounded in this paper and cite their sources.
Utility-scale photovoltaic (PV) plants in the desert climate of Western Saudi Arabia experience high irradiance but suffer from notable energy losses from elevated module temperatures and soiling. This study evaluates a representative 1.1 MW AC inverter block from an anonymised single-axis-tracking bifacial PV plant in Al-Madinah at four seasonal operating points, employing a datasheet-based single-diode electrical model, PVsyst, and PV*SOL. Estimated cell temperatures increased from 44 °C in winter to 69 °C in summer, raising the thermal derate from 5% to 12%. PVsyst and PV*SOL produced operating-point performance ratios (PRop) of 76.8–78.3% and 79.1–83.1%, respectively. When PVsyst loss factors were applied, the single-diode model aligned with PV*SOL within 3%, except during winter, when a difference of about 11% remained. On an annual basis, PVsyst reported a PR of approximately 83% and PV*SOL 88.25%, with a grid export of 2953.8 MWh/year; these are independent estimates. The module temperature accounted for the largest loss (10.4% in PVsyst; 6.79% in PV*SOL), followed by soiling (3.0%) and mismatch (approximately 2%). Conditional scenarios based on literature coefficients indicate that front-side measures could increase winter output by about 5% (range: 3–12%) and summer output by about 7% (range: 3–17%), mainly through cleaning, anti-soiling coatings, and cable improvements. A view factor estimate of the rear-side bifacial gain, not included in the simulations, suggests an additional gain of approximately 9% for natural desert ground.
No takes yet. Share an insight, caveat, or question.
Alkahtani et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: