Answers are grounded in this paper and cite their sources.
Q420 steel is widely used in steel bridge connection components; however, wear and corrosion during service can significantly compromise its service life. Gas nitriding can improve the mechanical properties of Q420 steel, but its conventional implementation is characterized by low nitriding efficiency. In this study, Ni–Ti coatings with Ni/(Ni + Ti) atomic ratios ranging from 54.1% to 82.4% were deposited on Q420 steel by dual-target magnetron sputtering to serve as catalytic layers, followed by gas nitriding at 500 °C for 6 h. The results demonstrate that Ni–Ti coatings significantly promote nitriding, while the nitrided layer thickness exhibits a non-monotonic dependence on Ni content. The sample containing 70.4 at.% Ni exhibited the maximum effective nitrided layer thickness of 8.87 μm, approximately 2.25 times that of the directly nitrided counterpart. The sample containing 54.1 at.% Ni achieved the highest surface hardness of 843.24 HV, representing increases of 24.9% and 319.9% relative to the directly nitrided and untreated Q420 steel, respectively. Meanwhile, the sample containing 70.4 at.% Ni exhibited a corrosion current density Icorr of 0.191 mA·cm−2, corresponding to reductions of 51.0% and 27.7% relative to the untreated and directly nitrided samples, respectively. EDS and XRD analyses of the nitrided samples revealed pronounced changes in the elemental distribution and phase composition of the surface layers, indicating that the Ni–Ti catalytic coating participated in and modified the microstructural evolution during nitriding. The observed performance improvements can be primarily attributed to the ability of the Ni–Ti surface layer to promote NH3 dissociation and facilitate the diffusion of reactive nitrogen species.
No takes yet. Share an insight, caveat, or question.
Shao et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: