Answers are grounded in this paper and cite their sources.
Finishing of long cylindrical aluminium components increasingly relies on abrasive belt machining, yet dependable guidelines for selecting its operating regimes remain scarce. To help close this gap, the present work applies explicit dynamic finite element modelling in LS-DYNA to reproduce, at the scale of a single abrasive grain, how the surface of a 6061-T6 alloy is generated during belt polishing. Two idealised grain geometries are contrasted: a truncated cone standing for a fresh abrasive and a half-ellipsoid approximating the same grain after wear. The material response is captured through the Johnson-Cook constitutive and fracture relations together with a Mie-Grüneisen equation of state, so that high strain rates, frictional heating and element erosion are reflected. For each geometry the resultant contact force, the total, sliding and workpiece-side energies, the actual contact area, the contact-zone temperature, the chip morphology and the residual groove profile were examined while the sliding velocity, the indentation depth and the friction coefficient were varied. The computations show that wear-driven rounding of the grain reduces the polishing force at low speeds but simultaneously raises the dissipated energy and the local heating, whereas the conical grain leaves a smoother groove under milder thermal loading. Near a practical belt speed of about 5 m/s the predicted temperature rise stays limited, and grain shape combined with cutting depth governs the attainable finish more strongly than speed alone. These findings offer a physically grounded basis for choosing rational polishing conditions and for deciding when a worn belt should be replaced.
No takes yet. Share an insight, caveat, or question.
Bratan et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: